*****SOLD*******2005 SV650 that I bought in 2017. It does have a clean, clear, MS title. It is located in Biloxi, MS. Mods, front to back: It has forks from an 06 GSXR 600. It has Yamaha R6 calipers. Because of the radial mount brake calipers native to the GSXR forks, the Yamaha R6 calipers can be fit using spacers also from TWF. They fit perfectly on the stock GSXR 310mm rotors because of the spacers. Inside the calipers there are Vesrah RJL brake pads. It has a Brembo 19x18 GP MK2 master cylinder, small profile brembo reservoir, and Ladybird mounting kit. Galfer stainless brake lines front and rear. The Galfer GP kit has a one-into-two line set up. One banjo at the master cylinder and it splits above the wheel and goes down to each caliper. MotionPro Revolver throttle kit. Comes with several throttle reels so you can custom fit the throttle range. It has a stock GSXR steering damper mounted up similar to the GSXR method, but it has a special bracket from a member of the SVRider.com forums. Woodcraft clipons The bike has a K&N air filter and FactoryPro Velocity stacks installed. Custom wiring harness chopped down and had a bunch of unnecessary stuff removed by a member of SVRider.com forums. Removed the clutch switch, side-stand switch, ignition, fuel sensor, and all the wiring for lights and the fan. Only downside is the fuel sensor, as you'll just have to stay on top of keeping the bike fueled up. It usually lasts at least four or five hard riding sessions on a single tank. This harness has never given me any trouble. The bike is turned on and off with the kill-switch instead of a key. Exhaust has stock headers and a Delkevic tri-oval slip-on. Clear StompGrip tank grips. The oil filter is hose clamped and safety wired to an aftermarket PSR oil drain plug. I used R-clips to make sure it was easily removed and replaced for quick oil changed and not having to redo the safety wire every time. The oil fill cap is also a PSR alternative, pre-drilled for safety wire. Vortex adjustable rearsets. I has what look like Motovation frame sliders installed, but they came with the bike when I bought it. Penske 8983 double clicker rear shock, rebuilt in 2017 by Metric Mike over at MetricDevilMoto. TWF rear wheel kit to fit an 06-10 GSXR 600/750 rear wheel. Both wheels have Bridgeport angled valve stems. Swingarm spools. It has unpainted ebay race bodywork, but not completly installed. Currently has the silver tank on it. Yellow tank has rust in it. Include stock parts: Forks, triples, brakes, rear wheel, rear brake hanger, wiring harness spare tank (yellow), etc. $3000 OBO